1. Implant impression is taken with antogonist
2. Implant model is scanned
3. Interim Titanium Bar is designed
4. Bite Block is designed
5. Dentist screws in interim bar and prepares Bite Block
6. Prepared bite is then scanned
7. Tooth Set Up is performed on top of Interim Titanium Bar
8. Toot Set Up and Gum Design is 3D printed to fit Interim Titanium Bar
9. Dentist does Tooth Set Up ‘try-in’ on Interim Bar
   • Bite is checked
   • Center Line is checked
   • Smile Line is checked
   • Tooth Shape is checked
   
10. Any changes needed are made by the Dentist, on the 3D print
11. Relative scans are done and design changes are done
12. New ‘try-in’ is made and performed
13. BIIBCAD™ Bridge and ‘Emergency Service’ Bridge are both finalised