1. Take new Implant Impression at fixture level or abutment level or both
2. Prepare the model
3. Place original Bridge on the new model and make a Rubber Key
4. Place plastic cylinder on the Implant model then fit Rubber Key. Pour acrylic to create copy of original Bridge
5. ‘Try-in’ Bridge and take bite
6. Take relative scans
7. Set up teeth to new bite, mid-line and lip-line using the BiiBCAD™ Software
8. 3D print set-up and manufacture Interim Bar
9. ‘Try-in’ set-up on Interim Bar
10. Make any design changes needed
11. BIIBCAD™ Bridge and ‘Emergency Service’ Bridge are both finalised